Vaporesso mod range, four segments on one map
Search for a Vaporesso mod in the UK and every result is a shop page or the brand’s own store. Most of them list a dozen names, Armour, GEN, Target, GTX, with no hint of how they relate. An Armour can run on a built-in cell or on two removable batteries, and a GEN can top out at 80 W or at 220 W. To see what the brand actually covers, the range has to be redrawn segment by segment, then set beside the other makers on British shelves.
The Vaporesso mod range covers four segments, not three series
Vaporesso files its mods into series that do not map onto any particular use. Sorted by power source and rated output instead, the Vaporesso mod range falls into four segments. There are rugged mods with published dust and water ratings, 220 W dual-battery mods, single-battery mods between 80 W and 100 W, and compact mods with a built-in cell.
The brand’s own UK store reads the range the same way. Its mod collection is described in terms of flagship rugged mods, classic dual-battery box mods, compact single-cell devices and pen-style mods, which is a sort by form factor rather than by series name.
One series can therefore sit in several segments, and the Armour name turns up in all four, from the single-battery Armour S to the built-in Armour Ultra, with the dual-battery Armour Max and Armour Octa in between.
Four segments, one brand
Each segment is defined by two figures that Vaporesso publishes, the power source and the maximum output. Model names come second, and a few of them appear in two segments at once.
Rugged mods, where the Armour name earns its keep
This is the brand’s showcase. The Armour Ultra runs on a 5500 mAh built-in battery at up to 100 W and is rated IP68 and IP69K, with a MIL-STD-810H drop rating from 1.2 m. The Armour Octa, which takes two 18650 batteries and reaches 220 W, also carries an IP69K rating.
A name alone is not a rating, though. The official spec sheets for the Armour Max and the Armour S list no ingress protection at all. Treat Armour as shorthand for water resistance and you will be wrong about half the series.
220 W dual-battery mods, the most crowded tier
Five mods share the same 220 W ceiling. The GEN 200, GEN Max, Target 200 and Armour Octa all run on two 18650 cells, while the Armour Max takes two 21700s or two 18650s.
Five models for one output figure tells you that wattage no longer separates anything here. Vaporesso competes on chassis, weight and protection instead. For the dual-battery tier across every brand, our piece on the Lost Vape Centaurus M200 looks at who still buys into it in Britain.
Single-battery mods, from 80 W to 100 W
One step down, four mods use a single cell. The GEN 80S and GEN SE stop at 80 W on one 18650, while the Armour S and Target 100 reach 100 W and accept either a 21700 or an 18650.
This is the most sensible tier in the range. The two GTi coils supplied with the kits, 0.2 ohm and 0.4 ohm, are rated by Vaporesso between 50 W and 75 W, a window these mods cover in full with only one battery to look after.
Compact mods with a built-in battery
Last comes the tier that needs no removable cell at all. The Target 80 packs 3000 mAh for 80 W, the GTX One Pro 3000 mAh for 40 W, the GEN Fit 40 2000 mAh for 40 W, and the Armour Ultra, already mentioned, 5500 mAh for 100 W.
Here the battery sets the working life of the device and, on the 40 W models, output drops towards tighter draws. Vaporesso pitches the GTX One Pro at MTL and RDL vapers, and our piece on the Vaporesso GTX One looks at the same compact tier on British shelves.
What ties the range together, one chipset and two coil families
The first common thread is the AXON chipset, which appears on most of the spec sheets, from the GEN and Armour lines to the Target series and the GTX One Pro. It carries the brand’s own output modes, such as F(t), which controls how fast the coil heats up on the Target 200, and the Pulse mode on the GTX One Pro.
The second is the coil family. Mods of 80 W and above come in kits with a tank that takes GTi coils, rated from 30 W to 90 W depending on resistance, from 0.5 ohm down to 0.15 ohm. The two 40 W devices, the GTX One Pro and the GEN Fit 40, switch to GTX coils from 0.4 ohm to 1.2 ohm, built for lower power.
The line between GTi and GTX follows the line between segments. From 80 W upwards you stay with GTi, at 40 W you move to GTX. Choosing a segment therefore also means choosing a family of consumables.
What the 2 ml cap changes for a Vaporesso mod kit
Under the Tobacco and Related Products Regulations, a refillable tank sold in the UK cannot hold more than 2 ml, and nicotine-containing e-liquid is capped at 20 mg/ml in bottles of no more than 10 ml. Nicotine vaping products are not for sale to anyone under 18 in the UK.
For most of its kits, Vaporesso’s spec sheets list a TPD version with a 2 ml tank, built for markets that apply this limit, Britain among them. Capacity figures copied from international listings therefore describe a different product from the one on a British shelf.
The mod itself is untouched by the rule. A mod sold on its own, which the brand’s UK store describes as mod only with no tank or pod included, has no capacity to cap. The limit bites on the tank you pair with it.
Where the Vaporesso mod range sits beside Lost Vape and Voopoo
On the wider map of mods, the brand stands out less for any single device than for its coverage. It fields several models in each of the four segments.
Against Lost Vape, the comparison sits in the dual-battery tier. The Centaurus M200 holds the position of the carefully finished box there, rated from 5 W to 200 W on two 18650 cells with Lost Vape’s Quest chipset. Vaporesso’s five 220 W mods cover the same ground with a similar ceiling, and differ through the spread of chassis, from plain boxes to the water-rated Armour Octa.
Against Voopoo, the border runs elsewhere. The Voopoo Drag X3 takes the place that single-battery mods hold at Vaporesso, with one 18650 or 21700 cell and 80 W, but swaps the screw-on tank for a cartridge on the PnP X platform.
The Vaporesso mod map in one table
The table uses the figures Vaporesso publishes on its official spec sheets, checked in October 2026.
| Segment | Models | Power source | Maximum output | Coils |
|---|---|---|---|---|
| Rugged, with IP ratings | Armour Ultra, Armour Octa | 5500 mAh built-in, or two 18650 cells | 100 W and 220 W | GTi |
| Dual battery | GEN 200, GEN Max, Target 200, Armour Octa, Armour Max | Two 18650 cells, or 21700s on the Armour Max | 220 W | GTi |
| Single battery | GEN 80S, GEN SE, Armour S, Target 100 | One 18650, or a 21700 on the Armour S and Target 100 | 80 W and 100 W | GTi |
| Compact built-in | Target 80, GTX One Pro, GEN Fit 40 | 2000 to 3000 mAh built-in | 40 W to 80 W | GTi on the Target 80, GTX elsewhere |
FAQ
These questions come up when the range is approached through its product names rather than its segments.
Can a Vaporesso mod take a tank from another brand?
The Armour Ultra mod spec sheet lists a reinforced 510 connector, the threaded standard used by most tanks on the market. A tank from another maker can therefore screw on, as long as its diameter suits the top of the mod and its coils match the output you plan to use.
What do IP68 and IP69K mean on a mod?
The first digit of an IP rating covers protection against dust and the second covers water. IP68 means fully dust-tight and able to withstand prolonged immersion, which Vaporesso specifies for the Armour Ultra as 1 m for more than 30 minutes. IP69K covers high-pressure, high-temperature water jets. These ratings describe a laboratory test, not a way to use the device.
Do Vaporesso mods come with batteries?
No. Vaporesso marks the batteries as not included on every battery-powered mod. You need cells in the format the model specifies, 18650 or 21700, bought new and as a matched pair for the dual-battery mods. A cell with a damaged wrap should not be used again.
Do any Vaporesso mods offer temperature control?
Yes, the Armour Max and Armour S. Their spec sheet lists three temperature control modes, for stainless steel, nickel and titanium, alongside the F(t), Pulse and Eco modes. These modes only work with coils made from the matching metal.
How do Vaporesso mods charge?
Through a USB Type-C port on the models whose spec sheet details charging, with figures that vary by model. The Armour Ultra accepts 9 V and 2 A or 5 V and 3 A, the Armour Octa 5 V and 2.5 A, and the Target 200 5 V and 2 A. On battery-powered mods, internal charging will do in a pinch, but an external charger lets you keep an eye on each cell separately.
What the Vaporesso mod range says about the market
Read by segment, the range stops looking like a pile of names. It covers every tier of the market, from the 40 W compact device to the 220 W dual-battery box, and sets its models apart through chassis and protection rather than power, which already sits at the same ceiling on five of them.
That is the position of a generalist. To place any Vaporesso mod, the useful question is the segment first, power source and output, and the series second, since the series name only tells you about the style of the casing. The same grid works for reading the rest of the vaping market.
Further reading
- The Lost Vape Centaurus M200 and the 200W dual-battery tier
- Where the Voopoo Drag X3 sits in the UK pod range
- The Vaporesso GTX One and its place on British shelves
- How the Voopoo Argus range is sold in the UK
Editorial content for adult readers only, with no commercial purpose. Vaping products can contain nicotine, which is a highly addictive substance. Nicotine vaping products are not for sale to anyone under 18 in the UK. This article is not a buying recommendation.
